FULL-TRACK machines are equipped with a Variable Speed clutch on the engine and on the gearbox. These links ensure that both a very low and high RPM can be created without strength loss.
Depending on the speed, lower or higher variable clutches participate and therefore the engine does not give unnecessary strength.
A typical RPM amounts to 125 rpm, but FULL-TRACK machines are adjusted to 200 rpm.
This speed results in quicker finishing of floors, which saves the entrepreneur time and money.
Perfectly calculated engine ensures sufficient strength.
We only use Genuine Honda motors that guarantee more power, quieter performance, lower fuel consumption & reduced emissions.
|
GX200 – 5.5HP |
GX270 – 8.5HP |
GX390 – 11.7HP |
FULL-TRACK Gearbox Casts are manufactured from High-Quality Aluminium.
The layering has been calculated on all possible strengths and frictions and therefore early wear is avoided.
Internal damage breakdown services can be carried out with minimum disruption to operations.
The remuneration costs will diminish strongly because of this.
FULL-TRACK machines as standard are equipped with a strapless variable handle in altitude.
Both large and smaller users can work unforced because of this.
A FULL-TRACK Arm is almost the same length as the Blades, so therefore declines have been minimized and the area continues to be preserved.
FULL-TRACK arms have been eccentrically twisted, which excludes independent moving. The four arms will always move Simultaneously which results in small disparities being removed and the flatness of the floor being increased. All spiders and arms have been blackened. Oxidation on arms stuck inside the spider are avoided and therefore subject to minimum maintenance. After years of use the tolerance of the arm in the spider remains as it were at nil The work suggesting area remains unchanged.
OTHER BRANDS
Generally spider arms are 2/3 of the additional plate length.
As a result, after some use, the crossing part of the blades and arms will bend. This translates to loss of work.
